Nomix Enviro Stem Master, Инструкция по эксплуатации

Страница: 11 / 16

When you are not using the Stem
Master, it should be stored in the
original case supplied. This helps
to avoid damage to the Stem
Master whilst it is not in use.
1) Clean the Stem Master
(following instructions in
section 5).
2) Remove the handle grip by
twisting it in a clockwise
direction and pulling it down to
release.
3) Remove the piston, by applying
a small amount of downward
pressure on the calibration dial.
Detach the piston from the
keyhole slots in the side arms
and pull the piston from the
main body of the Stem Master.
Then remove the spring from the
piston.
4) Wash and rinse the piston and
spring, then allow to dry.
5) Once dry, smear a very small
amount of liquid paraffin or
castor oil onto the piston
and spring, in order to keep the
parts lubricated.
6) Replace the spring onto the
piston and, with the trigger in
the open position, reattach the
piston to the main body. Secure
it by fastening the keyhole slots
in the side arms.
7) Reattach the handle grip by
pushing it onto the piston
assembly unit and secure in an
anti-clockwise direction.
8) Ensure the calibration dial is set
to the 1mm position.
9) Store in the case supplied.
section 6: storing
11