nologo START-S7LT, Руководство пользователя и инструкция по установке для инсталлятора

Страница: 32 / 120

4.7 Connection of the ENCODER
START-S7lT
operating guide
-8-
4.5 Connection of the POWER SUPPLy and BATTERy
4.8 Connection of the LAMPS
4.6 Connection of the MOTOR
3 4 1
Pay attention not invert the poles oPen and CloSe.
In case of doubts out manually the gate in the middle of the stroke.Keep ready
to stop the gate with a SToP CoMMAnde.
Interrupt the photocells if you want to check the correct open, if the gate starts
closing , the connection is wrong and you need to invert the cables oPen with
CloSe of the motor.
MOTOR
6 7 8 5 10 11 12 9 14 15 16 13 18 17
Connection
of the LAMP
!
19 21 20
Signal for encoder
- power supply of the ENCODER
+ 5V power supply of the ENCODER
For a correct use of the encoder,
we recommend to ready the man-
ual.
!
The following control board can be
powered 12/24Vac/dc . To set up
the power supply put the jumper
12V as shown:
12 Vac/dc 24 Vac/dc
2
3
4
1 2
Power Supply
In case you activate the pre-
lighting see Par. 5.1
!
Use the correct cable to connect the
battery and respect the polarity. DON’T
CONNECT DIRECTLy THE BATTERy.
As the cable has a charge circuit, fuse
and diode of power suplly. WARNING:
The control unit has an emergency
module, connect the battery to the
emergency module as shown in the
scheme.
It is possible to activate or
deactivate the flashing light
for the output of the Light
during the memorization of
the working time Par. 7.2