12
2.1 FIXING OF A STANDARD BARRIER
A
B
C
D
D
E
F
G
H
H
To fix the barrier make as follow:
1.
Fix the point for the fixing hole (5mm)
E
and
F
and check the
right position of the module
A
with the covers
B
and
C
. The hole
G
should be just over the fixing hole
F
2.
Make a 5mm holes, put the plug
D
3. Fix the cover
B
to the hole
E
with self-tapping screw
H
4. WARNING!!!
If the barrier is installed outside, make a drainage
hole in the lower part of the cover
C
.
5.
Pass the cables in the back of the cover
C
, make the connec-
tions of the barrier
A
.
6. Plug the cover
C
in the barrier
A
, and take off the cables in
excess.
7. Fix the cover
C
with the a self-tapping screw
H
.
2
FIXING OF BARRIER
2.2 FIXING OF A ROTATING BARRIER
A
B
C
I
L
D
D
E
F
G
H
H
To fix the rotating barrier make a s follow:
1.
Fix the point for the fixing hole (5mm)
E
and
F
and
check the right position of the module A with the covers
B
and
C
with bearing
I
and
L
. The hole
G
should be
over the fixing hole
F
.
2.
Make a 5mm holes, put the plug
D
3. Fix the cover
B
to the hole
E
with self-tapping screw H
4. WARNING!!!
If the barrier is installed outside, make a
drainage hole in the lower part of the cover
C
.
5.
Before make the connections of the barrier and then
plug the covers
B
and
C
in the barrier
A
. Plug the co-
vers and take off the cable in excess.
6. Plug the upper part of
A
,
B
,
C
in the part
I
.
7. Plug the part
L
in the lower part of the cover
C
and fix
with self-tapping screw
H
.
8.
To fix the module of the rotating support, make a
2.5mm hole in the pivot pin and fix the cover with a
small self-tapping screw.
2.3 FIXING OF THE ELECTRONIC PART OF THE BARRIER
To fix the electronic part, it is sufficient to plug a fixing screw in the first module. (Picture pag. 11)
