PAGE 9
troubleshooting
•
•
•
•
•
•
•
•
Check if the power cable is connected.
Turn on ignition.
Check the fuse located at the tip of the
plug.
The detector could have received a false
alert signal from a motion sensor. Lockout
the known false alert location.
The vehicle in front of you is equipped
with Blind Spot Mirror (BSM) or Lane Assist
feature. Turn on the BSM filter in the menu
Radar operated traffic sensors are placed
along your road; turn on Traffic Sensor
Rejection (TSR) filter in the menu
Your vehicle might be equipped with a
metal coated windshield that prevents the
reception of radio waves.
Check with your
local dealer.
The speed limit setting in the menu has
been set above normal traveling speed.
Turn off speed limit setting or set to a
lower speed.
Power cable is disconnected or switch has
not been turned on
Display is set to “Dark” or “Smart Dark”
mode
The dectector will not turn on.
The unit suddenly alerts at high in-
tensity while driving on the Interstate
although there is no police in sight.
Radenso SP never alerts to radar or
alarm turns on after passing the radar
source.
The display will not turn on.
•
•
•
•
•
•
The alert volume is turned down. Increase
the volume.
The officer is not operating radar equip-
ment.
One or more radar bands have been
deactivated. Check in the menu if all radar
bands used in your area are turned on.
You may have activated a speed limit in
the menu and you were traveling below
the set speed limit.
The detector alerts visually but there
are no voice or audio alerts.
The detector did not alert to ap-
proaching police vehicle.
The windshield mount does not
adhere to the windshield.
The detector alerts to a signal but no
police radar trap can be located.
The detector starts alerting with low
intensity following another vehicle.
• Clean the suction cups and the windshield.
