Nolatron TB-2 Series, Руководство пользователя

Страница: 5 / 12

3
Warning!
It is necessary to locate and install the Start Bar in accordance
with OSHA machine guarding distance calculations which can be
found in 29 CFR 1910.217. Users must also install point of
operation guarding devices, compliant with OSHA regulations,
ANSI standards, and any other machine safety standard that applies to the
specific industry such as light curtains, pressure mats, etc. to fully protect
personnel from accessing the machine during cycle operations.
Installation:
The Start Bar can be mounted to the back or to the bottom using the mounting
holes in the housing. Do not add additional mounting holes by drilling into the
center chamber that contains the anti-tie-down control. Metal shavings, caused
by drilling, may cause an internal electrical short circuit. This chamber is sealed
to keep out contaminants such as oil, drilling additional holes may allow these
contaminants to enter the chamber and damage the anti-tie-down control
circuit.
Mounting to the back:
When mounting to the back use a bolt or
screw with a diameter of 1/4". The mounting
flange is 1/2" thick. The holes are 19 1/2" apart
measured from center to center. The use of a
lock washer or locknut is recommended. Be
sure that the wiring hole on the back of the
Start Bar is not blocked.
Mounting to the bottom:
When mounting to the bottom use a bolt with a
diameter of 1/4" and 20 TPI (1/4-20). The
mounting flange is tapped to a depth of 1/2".
The holes are 17" apart measured from center to
center. The use of a lock washer and thread-
locking fluid is recommended.