Nolan N-Com MCS II, Инструкции по безопасности и эксплуатации

Страница: 11 / 56

MCS II
11
3.2. Installing the Basic Kit2 MCS on the helmet
 Position the Basic Kit2 MCS inside the helmet as shown in figure 12, next to the N-Com housing in
the shell;
 Looking at the helmet from the outside, slide the rear positioning tab into groove A as shown in
the figure;

Press in the area marked PUSH from inside the helmet until the fastening clasp B clicks (Fig. 13).
Fig. 12 Fig. 13
Fig. 14

Pull out the connectors area from the helmet
gasket: the gasket will have to be slightly
deformed to facilitate the insertion.