8
4. BASIC FUNCTIONS
All the functions offered by the N-Com system are activated by using 3 buttons, “
”, “on” and “
”. Every
command is confirmed by a special beep, which varies depending on the requested function. This way you
can use all the functions with the helmet raised.
The type of command given to the system depends on how long the button is pressed.
Turning on
Press the “on” button and keep it pressed for about 4 seconds until the LED
lights up and a beep is heard in the earphone
Turning off
Press the “on” button and keep it pressed for about 4 seconds until the LED
turns off and you hear a beep.
Raising the Volume
Press the “
” button briefly to raise the volume. The maximum volume is
signaled by a double beep.
Lower volume
Press the “
” button briefly to lower the volume. The minimum volume is
signaled by a double beep
Warning: Listening to other equipment should not interfere with driving the vehicle, which must
be the top priority at all times. Carry out all operations on the electronic equipment and on the N-
Com system with the vehicle stopped, in compliance with Traffic Regulations.
Warning
:
Listening at high volumes can distract you from driving the vehicle and may result in
dangerous situations or reduce the ability to hear external noise.
Warning: Adjust the volume of the N-Com system (if equipped) and of the audio sources
connected to it before using the system on the road.
Warning: Adjust the volume of the N-Com system and of the audio sources connected to it in
order to avoid audio reproduction at high volumes. Constant exposure to high audio volumes
may damage your hearing.
5. OPERATION WITH A BLUETOOTH CELL PHONE
N-Com Bluetooth Kit2 is equipped with Bluetooth HSP (Headset) and HFP (Handsfree) profiles for
connection to Bluetooth cell phones and other devices featuring one of these profiles. In a cell phone has
both profiles, the system automatically chooses which one to use.
In order for the Bluetooth Kit2 system to work with a cell phone, the latter has to be first affiliated with the N-
Com system.
5.1.
Affiliation with a Bluetooth telephone (or other Bluetooth devices)
In order for two Bluetooth devices to communicate with each other, they must be affiliated, in other words
they have to be introduced to one another.
The N-Com system is recognized by the cell phone as a Bluetooth earpiece. Please refer to your cell phone
manual, the section on affiliation of Bluetooth devices, in order to verify the affiliation procedure as it changes
depending on the specific model used.
After identifying your cell phone’s affiliation procedure, perform the affiliation with Bluetooth Kit2.
1.
Make sure that Bluetooth Kit2 is turned off
2.
Press the middle button “on”. After the first 4 seconds, the system turns on. Keep this button pressed
for an additional 4 seconds until the LEDs start to flash quickly and a sharp beep is heard, indicating
the affiliation mode.
3.
While the helmet is in affiliation mode, search for the Bluetooth devices according to the procedure
specific for your cell phone.
4.
The name “N-Com 2.x”, followed by the manufacturer’s identification data, will be displayed on the cell
phone, in the list of available devices.
5.
Select the N-Com device.
6.
When the cell phone asks for a password, enter the code 0000 (four zeros).
7.
The helmet will confirm that affiliation has taken place with a beep, and the LEDs will stop flashing.
N.B.: If you need to repeat the procedure, turn off the system and start from point 1. The affiliation
procedure can be repeated multiple times without the risk of damaging the system.
Содержание n-com bluetooth kit 2.1
Страница 1: ...EN SAFETY AND INSTRUCTIONS FOR USE...
