11
N.B.: In case a cell phone was already affiliated prior to the affiliation of the Bluetooth Kit systems, make
sure that this affiliation is still working. Otherwise, repeat the affiliation with the cell phone.
All affiliations are stored even when the helmets are turned off, and they are maintained until the helmets are
turned back on. As a result, the affiliation procedure must be repeated only when systems other than the
affiliated ones are used.
7.2.
Interphone functions via Bluetooth
Turn on both Bluetooth kit2 systems. When the Pilot’s helmet turns on, it searches for the passenger’s one,
automatically establishing an interphone communication mode.
N.B.: Some Bluetooth devices already connected to the system may automatically block the connection
described above. In this case, proceed with a manual connection, pressing the “on” button briefly.
You may turn the interphone connection on and off at any time by pressing the “on” button briefly on any one
of the two helmets.
N.B.: It may take a few seconds for the Bluetooth kit2 to find the other system, depending on the connections
that may be already active and the Bluetooth devices already present. After pressing the “on” button,
wait for the search to end.
N.B.: If you turn on the pilot’s helmet first, or in any other situation in which the Bluetooth connection is lost
simply press the “on” button briefly on one of the two systems to start the search and the connection.
The system is equipped with a “MUTE” function that turns off the microphone yet leaves the audio channel
open. This function can be used to listen to an audio source, eliminating any interference picked up by the
microphone of the connected helmet.
Switching the interphone mode
on/off
Press the “on” button briefly. It may take a few seconds for the system
to find the other Bluetooth.
Switching the microphones on/off
(Mute function)
Press the “
” button and keep it pressed for about 4 seconds.
8. BLUETOOTH RECEIVER (A2DP PROFILE)
You can listen to high-quality music by connecting the Bluetooth kit2 via Bluetooth to a receiver equipped
with Bluetooth A2DP (Advanced Audio Distribution Profile) protocol.
8.1.
Affiliation with A2DP devices
In order to affiliate a device equipped with Bluetooth A2DP protocol, proceed as for the affiliation of a cell
phone (Chapter
5.1). In case a code is required, enter “0000”.
N.B.: If a telephone equipped with receiver with Bluetooth A2DP profile has already been affiliated, you do
not have to repeat the affiliation since the A2DP protocol was already stored during the cell phone
affiliation procedure. When you first use it, the telephone must be connected and the receiver started
from the cell phone so that the system can recognize it.
8.2.
Operation with A2DP receiver
When you first use it, connect the receiver (previously affiliated) according to the method provided for the
receiver and start audio reproduction. Afterwards, it will be possible to establish the connection and start
audio reproduction directly from the Bluetooth kit2 (for receivers that allow it)
Warning: The N-Com Bluetooth kit2 system is equipped with the Bluetooth AVRCP (Audio Video Remote
Control Profile) protocol, which is used to stop and restart music reproduction. If the A2DP
receiver is not equipped with the AVRCP protocol, it may not be possible to restart music
reproduction from the Bluetooth kit2 (although it is possible to stop it). In this case reproduction
must be restarted manually on the receiver.
Содержание n-com bluetooth kit 2.1
Страница 1: ...EN SAFETY AND INSTRUCTIONS FOR USE...
