Nolan N-Com Basickit N32, Инструкции по безопасности и эксплуатации

Страница: 10 / 16

ENGLISH
N32
24
12. Connect the Basic Kit cable to the connector located behind the left loud-
speaker (Fig. 18).
13. Gently push the tab of the left loudspeaker in its own housing, arranging
the flex cable between the shell and the polystyrene (Fig. 19).
If necessary, widen the shell slightly.
14. Fold the Basic Kit cable and position it under the foam of the loudspeaker.
15. Gently push the loudspeaker until it is properly housed.
16. In the same way, position the right loudspeaker. At the end of this opera-
tion, the helmet should look like the one in the figure (Fig. 20), with the flex
cable between the inner shell and the outer shell.
Position the battery charger cable along the right side of the edge of the
shell.
17. Bend the rear neck area again by passing the black tab of the rear neck
padding through, beyond the battery support and the flex cable (Fig. 21).
18. After it is positioned, push the rear neck padding inside its own housing
(Fig. 22).
FIG. 18
FIG. 19
FIG. 20
FIG. 21
FIG. 22
N32 000000043 10-07-2007 13:10 Pagina 24