420
450
450
50
420
450
Add a letter after the product code to specify the
version required, for example
Ö19-20
A
:
M = Ground-mounted with extended support post for
casting in concrete 40 cm beneath the surface
N = Attachable version with base edge extended for
bolting into the surface
Ö19-21
Parco footstool
Ö19-22
Parco swivel footstool
Delivery specification:
1 seat,
1 support post (with fixed support post or swivel),
4 screws and washers for attaching the seat to the
supporting post.
FOOTSTOOL ASSEMBLY INSTRUCTIONS
Turn the footstool upside down, being careful to protect
the wooden parts during installation. Using a screwdriver
with an H6 bit, secure the supporting post to the
underside of the seat with the screws and washers
included (MK6S FBB M10).
Installation with M10 bolts (‘N’ version):
The base plate has been made with holes to secure it to
the surfaces with M10 bolts.
Installation on a wooden surface (‘N’ version): Use
French-style woodscrews to attach the base plate to the
wood.
Installation on a wooden surface (‘N’ version): Use
French-style woodscrews to attach the base plate to the
wood.
Installation on cobbles or paving stones (‘N’ version):
Anchor the cobbles or paving stones in a cast concrete
base without allowing any levelling sand to come
between the stones and the concrete. Drill holes in the
surface sized to accommodate expander bolts. A
chemical anchor may also be used.
Installation on concrete (‘N’ version): Attach with
expander bolts or a chemical anchor as instructed
above. Attaching with expander bolts makes it possible
to remove and reattach the footstool as required.
Ground-mounted installation (‘M’ version): Prepare the
ground with a hole circa 40 cm in diameter to a frost-free
depth. Fill the hole with frost-resistant material so that
the hole is not deeper than 50 cm. Turn the footstool
upright and position the supporting post in the hole.
Ensure that the armchair seat is level in position as well
as level on all sides. The distance between the seat’s
front edge and the ground beneath should be 45 cm.
The supporting post should be cast in the concrete,
leaving a gap of 5 cm between the top of the concrete
and the ground surface to be filled in with surface
material.
sid 2/7
Parco
