Insert the coil cable into the shaft. Do not extend
the shaft prior to this step! Pull the cable out from
the other end of the shaft.
Coil cover use is optional. It protects the search
coil from scratches. If you want to use the cover,
remove the protective sheets from the tapes
inside the cover, attach the cover to the coil and
press firmly to make them stick together. Once
the cover is attached, you cannot take it off.
QUICK GUIDE
ASSEMBLY
1
5
9
11
10
12
13
2
3
4
1) System Box
2) Handle
3) Search Coil
4) Search Coil Cover
5) Extension Shaft
6) System Box Case
7) Battery Case
8) 8 AA Batteries
9) System Connection Cable
10) Wingnut
11) Fastening Screw
12) Washers
13) Headphones
Place the washers into the openings on both sides at
the end of the extension shaft.
After placing the shaft on the coil as shown in the
picture, insert the fastening screw through the
hole and tighten it using the wingnut.
Connect the end connector on the search coil
cable with the connector underneath the handle
and tighten.
Insert the shaft in its socket underneath the
handle and start rotating the twist lock. As you
rotate the twist lock it will slide down. Before
rotating the twist lock all the way, push the shaft
up again making sure that it is in place and
secure it by tightening the twist lock.
To adjust the height of the device, loosen the
twist lock on the shaft. After adjusting the shaft
length to your height, re-tighten.
Insert the end connector on either end of the
system connection cable into the socket on the
handle and tighten securely.
Place the system box and the battery in their
proper compartments of the system box case.
Insert the battery cable through the hole on the
case, plug it into the battery input socket
underneath the system box and tighten securely.
Plug the other end of the system connection
cable into the coil input socket underneath the
system box and tighten securely.
You may hang the system box around your
neck using the neck strap or attach it to your
belt as shown in the pictures.
6
7
8
