Nokia RH-37 Series, Инструкции по настройке и программному обслуживанию

Страница: 55 / 72

Nokia Custome Care Service Sofftware and Tuning Instructions
RH-37
Issue 1 07/04

Nokia Corporation Page 55
The notch value might not be displayed in later Phoenix versions.
Press
Tune
and the optimal values are found.
Press
Stop
, the values are saved to the phone and the calibration has finished.
The results must fulfill the following limits:
Note: In later Phoenix versions the notch calibration might not be applicable anymore.
TX power level tuning
RH-37 supports GMSK and EDGE mode for the Power amplifier. Therefore, the power
level tuning must be carried out for both modes in each band.
It is strongly recommended to use the
Phoenix <Auto-Tune>
capability. The functional-
ity of it is described in chapter “
Fully automatic Calibration, Tuning & Measurement
by Phoenix <Auto-Tune>”
.
It is strongly recommended to use TXP as external trigger for all TX tunings. External trig-
gering gives the following advantages:
• trigger for spectrum analyzer (gated sweep)
• trigger for oscilloscope
• trigger for power meter (avoid exchanging of attenuator and getting better accu-
racy in power measurements)
Nevertheless, manual tuning is described below. It has to be carried out in all three bands
and both modes (EDGE and GMSK).
Calibration value / Test case Typical Low limit High limit
DTOS I Address Rc / check rx baseband
filter DTOS_I [DAC]
13 -6 +37
DTOS Q Address Rc / check rx baseband
filter DTOS_Q [DAC]
13 -6 +37
BBF I Address BIQUAD I R / check rx baseband
filter BIQUAD_IR [DAC]
13 -6 +37
BBF I Address BIQUAD I C / check rx baseband
filter BIQUAD_IC [DAC]
13 -6 +37
BBF Q Address BIQUAD Q R / check rx baseband
filter BIQUAD_QR [DAC]
21 -6 +37
BBF Q Address BIQUAD Q C / check rx baseband
filter BIQUAD_QC [DAC]
21 -6 +37
Notch / check rx baseband filter NOTCH
_ [DAC]
24 -6 +37