CCS Technical Documentation
System Module
NKC-1X
Issue 1 02/03
Nokia Corporation
Page 15
User Interface Hardware
LCD
Introduction
NKC-1X uses a black & white GD46 84x48 full dot matrix graphical display. There are
two suppliers for this LCD: Seiko Epson and Philips. The LCD module includes the LCD
glass, the LCD COG-driver, an elastomer connector and a metal frame. The LCD module is
included in the lightguide assembly module.
Interface
The LCD is controlled by the UI SW and the control signals are from the UPP asic. The VIO
and Vflash1 regulators supply the LCD with power.
The LCD has an internal voltage booster and a booster capacitor is required between
Vout and GND.
Pin 3 (Vss9) is the LCD driver’s ground and Pin 9 (GND) is used to ground the metal
frame.
Keyboard
Introduction
The NKC-1X keyboard style follows the Nokia Jack style, without side keys for volume
control. The PWR key is located at the top of the phone.
Figure 3: Placement of keys.
1
2
3
4
5
6
7
8
9
#
0
*
Up
Down
End
Send
S Right
S Left
Содержание NKC-1X Series
