GB 8
The box for your Mediamaster should contain the
following items:
• the Mediamaster
• a remote control with 2 AAA batteries
• a SCART lead (fully featured 1,0 metre)
• an aerial/RF lead (double screened 1,5 metres)
• a telephone modem cable (10 metres with a splitter)
• an Owner’s Manual
• a Software License agreement
INSTALLATION OF THE MEDIAMASTER
About the SCART sockets
• The rear panel of the Mediamaster is equipped with 2
SCART
sockets (see diagram).
When you connect other products
to any of these sockets, always use fully featured SCART
leads
(as supplied).
There are “less well specified” SCART
leads on the market and picture quality could be reduced if you
use them.
SCART socket
SCART lead
Owner’s manual
License
agrement
RF lead
Preparing the Remote Control
• Remove the cover on the battery compartment at the bottom
of the remote control.
• Insert the 2 AAA (1,5 V) batteries, as shown in the diagram,
taking care to observe the
+
and
-
markings indicated inside.
• Replace the cover.
Telephone
modem cable
Connecting to the TV aerial
You can connect the Mediamaster to the following antennas:
1.Standard outdoor antenna
Where possible, use an outdoor roof antenna (UHF 21-69).
Please note the following:
• In some residential buildings, the communal roof-mounted
antenna includes a filter and channel selector. If so, the an-
tenna will probably not work with the Mediamaster. Please
consult the property owner.
• Many older roof-mounted antennas can only receive a limited
number of channels. As a result, digital channels transmitted
on higher frequencies may be difficult to receive. The problem
can be solved by replacing the roof antenna.
