Nokia Check Point IP2450, Руководство по установке

Страница: 64 / 136

5
About IP2450 Appliance Network Interface Cards
64 Check Point IP2450 Security Platform Installation Guide
Two-Port Fiber-Optic Gigabit Ethernet NICs
The IP2450 supports Check Point-approved, two-port, fiber-optic Gigabit Ethernet NICs
installed on a PMC expansion slot. The IP2450 can accommodate up to four Gigabit Ethernet
NICs.
When you purchase a Gigabit Ethernet NIC with your IP2450, the NIC is installed before the
appliance is delivered to you. For information about how to add or replace a NIC, see
Chapter 4,
“Installing and Replacing Network Interface Cards and ADP Modules.”
Fiber-Optic Gigabit Ethernet NIC Features
The short-range and long-range fiber-optic Gigabit Ethernet NICs support:
„
High bandwidth
„
Full-duplex mode operation up to 1 Gbps (no half-duplex support)
„
Link speed auto advertising
„
Tracing through tcpdump
„
Compliance with IEEE 802.3z Gigabit Ethernet specification
The short-range multi-mode fiber (MMF) fiber-optic Gigabit Ethernet NICs in the IP2450 run
on Check Point IPSO 4.2 or higher.
The long-range single-mode fiber (SMF) fiber-optic Gigabit Ethernet NICs in the IP2450 run on
Check Point IPSO 4.2 or higher.
You can configure and monitor Gigabit Ethernet NIC interfaces with Check Point Network
Voyager. Specifically, you set the port speed and full-duplex mode with Check Point Network
Voyager.
For information about how to access Check Point Network Voyager and the related reference
materials, see
“Using Check Point Network Voyager” on page 42.
Figure 14 shows the front panel details for the two-port short-range (1000 BASE-SX) fiber-optic
Gigabit Ethernet NIC you can use in IP2450 appliance.
Figure 14 PMC Two-Port Short-Range Gigabit Ethernet NIC
00206
GIGE
Link LEDs (solid green)
Activity LEDs (blinking amber)
Ports