2
Power
To power your Noise Engineering module, turn off your case. Plug one
end of your ribbon cable into your power board so that the red stripe on
the ribbon cable is aligned to the side that says -12v and each pin on the
power header is plugged into the connector on the ribbon. Make sure no
pins are overhanging the connector! If they are, unplug it and realign.
Line up the red stripe on the ribbon cable so that it matches the white
stripe and/or -12v indication on the board and plug in the connector.
Screw your module into your case BEFORE powering on the module. You
risk bumping the module’s PCB against something metallic and damaging
it if it’s not properly secured when powered on.
You should be good to go if you followed these instructions. Now go make
some noise!
A final note. Some modules have other headers -- they may have a
different number of pins or may say NOT POWER. In general, unless a
manual tells you otherwise, DO NOT CONNECT THOSE TO POWER.
Warranty
Noise Engineering backs all our products with a product warranty: we guarantee our products to be
free from manufacturing defects (materials or workmanship) for one year from the date a new
module is purchased from Noise Engineering or an authorized retailer (receipt or invoice required).
The cost of shipping to Noise Engineering is paid by the user. Modules requiring warranty repair will
either be repaired or replaced at Noise Engineering's discretion. If you believe you have a product
that has a defect that is out of warranty, please contact us and we will work with you.
This warranty does not cover damage due to improper handling, storage, use, or abuse,
modifications, or improper power or other voltage application.
All returns must be coordinated through Noise Engineering; returns without a Return Authorization
will be refused and returned to sender.
Please contact us for the current rate and more information for repairs for modules that are not
covered by our warranty.
