Nodka PANEL5000-A121, Руководство пользователя

Страница: 19 / 44

PANEL5000 ‐ A121 User Manual
19
Figure 2 ‐ 9: Wall mount
Step 1: Select the location on the wall for the wall ‐ mounting bracket.
Step 2: Carefully mark the locations of the four bracket screw holes on the wall.
Step 3: Drill four pilot holes at the marked locations on the wall, for the bracket retention
screws.
Step 4: Align the wall ‐ mounting bracket screw holes with the pilot holes.
Step 5: Secure the mounting ‐ bracket to the wall by inserting the retention screws into the
four pilot holes and tightening them
Step 6: Insert the four monitor mounting screws provided in the wall mounting kit into the
four screw holes on the real panel of the flat panel monitor and tighten until the
screw shank is secured against the rear panel
Step 7: Align the mounting screws on the monitor rear panel with the mounting holes on the
bracket.
Step 8: Carefully insert the screws through the holes and gently pull the monitor downwards
until the monitor rests securely in the slotted holes. And ensure that all four of the
mounting screws fit snuggly into their respective slotted holes.
Step 9: Secure the panel monitor by fastening the retention screw of the wall ‐ mounting
bracket.
2.3.4 Panel mounting
To mount the PANEL5000 ‐ A121 flat panel monitor into a panel (not standard attached),
please follow the steps below:
Step 1: Select the location on the panel to mount the flat panel monitor.
Step 2: Cut out a section from the panel that corresponds to the rear panel dimensions of
the flat panel monitor. Take care that the panel section that is cut out is smaller