Driver bits fall out of the chuck
Possible solution:
Ensure bits are properly secured in the chuck. Refer to page 16
for how to properly insert a bit.
Driver overheats
Possible solution:
It’s normal for the tool to get hot after extended use. However,
we recommend that you do no run the driver continuously for more than ten
minutes at maximum speed and allow sufficient time for the it to cool down.
IMPACT DRIVER LIABILITY
This product is covered by an EU directive, valid since 01.01.1990, specifying that
the manufacturer is only liable for products if all the parts originate from the
manufacturer or are approved by them, and if the units are mounted and operated
properly.
If accessories or spare parts from third parties are used, liability can be partially or
completely inapplicable. So no using those shifty parts you picked up on the cheap.
In extreme cases the responsible authorities can prohibit the use of the entire unit.
We recommend you always buy original parts and accessories as compliance with
all safety regulations is guaranteed, meaning you are covered and protected.
Another weight off your mind.
23
