Nobles SPEED SCRUB 500, Руководство оператора

Страница: 11 / 44

OPERATION
Nobles Speed Scrub 500 (09-2020)
11
INSTALLING BATTERIES
WARNING: Batteries emit hydrogen gas.
Explosion or fire can result. Keep sparks and open
flame away when charging.
FOR SAFETY: When servicing machine, wear
appropriate personal protection equipment as
needed. Avoid contact with battery acid.
BATTERY SPECIFICATIONS
Requires four 6 volt deep-cycle batteries,
≤
260 Ah @
20 hr or two 12V TPPL batteries.
Contact distributor or Tennant for battery
recommendations.
FOR SAFETY: Before leaving or servicing machine,
stop on level surface, turn off machine, remove key
and set parking brake if equipped.
1. Lift the recovery tank to access the battery
compartment (Figure 1).
FIG. 1
2. Carefully install the batteries into the battery
compartment tray and arrange the battery posts as
shown (Figures 2 & 3). Position foam spacer(s) as
shown. Using the supplied battery post boots,
connect the cables to battery posts, RED TO
POSITIVE (+) & BLACK TO NEGATIVE (-).
FOR SAFETY: When servicing machine, use a
hoist or adequate assistance when lifting batteries.
BLACK
RED
FOAM SPACER
4x6V Standard Batteries
FIG. 2
BLACK
RED
FOAM SPACER
2x12V TPPL Batteries
FO
AM
SPAC
ER
BLACK
RED
FIG. 3
IMPORTANT: Before charging batteries, make sure
the battery charger and the machine's battery
discharge indicator are properly set for battery
type. Failure to properly set will result in battery
damage. See BATTERY CHARGER SETTINGS.
ATTENTION: Do not disconnect battery cables
while charger is plugged in, circuit board damage
may result.
IRIS
®
Battery Charging Metrics Notification:
Machines equipped with capability to report battery
charging data via IRIS are supplied with a charger and
set of batteries from the factory. When a battery
reaches its end of life and must be replaced, Tennant
highly recommends that the same battery type be used
to continue to maximize the machines performance. In
the event a battery with a different amp hour (AH), type
(Flooded, AGM, Gel, TPPL), or manufacturer is
selected for replacement please contact Tennant
technical service department for assistance in
determining the feasibility of the replacement batteries
and if so, selecting the correct charging profile.
Availability of IRIS battery metric reporting is not
guaranteed with third party supplied batteries.
HOW THE MACHINE WORKS
Conventional scrubbing:
When using the conventional scrubbing mode, water
and detergent mixture from the solution tank flows to
the floor and the rotating brush(es)/pad(s) scrub the
floor clean. As the machine moves forward, the
squeegee with vacuum suction picks up the dirty
solution from the floor into the recovery tank.
ec-H2O NanoClean Technology (option):
When using the ec-H2O NanoClean technology,
normal water passes through a module where it is
electrically converted into a cleaning solution. The
electrically converted water attacks the dirt, allowing
the machine to easily scrub away the suspended soil.
The converted water then returns to normal water in
the recovery tank.