OPERATION
Magna Twin
t
3000 (03–04)
5
MACHINE SETUP
1.
Install selected filter bag by opening bag access
door and sliding rubber collar on bag completely
onto the intake chamber. Make sure bag is totally
within housing before closing door (Figure 1).
FOR SAFETY: Do not operate machine without
bag and/or filters in place.
FIG.
1
ATTENTION: To maintain best performance, empty
filter bag when 2/3 full.
2.
Plug power cord into 120V grounded wall outlet
(Figure 2).
FOR SAFETY: Do not operate machine unless
cord is properly grounded.
WARNING: Do Not Operate With Damaged
Power Cord. Do Not Modify Plug. Unplug Power
Cord Before Servicing Machine.
Grounded
3 Hole Outlet
Ground Pin
FIG.
2
3.
Properly adjust brush height to type of carpet, tilt
machine back and turn adjustment knob
counterclockwise. Now tilt machine back down to
floor and activate triggers. If a slight forward
propulsion is noticed, machine is properly adjusted
(Figure 3).
FIG.
3
NORMAL BRUSH ADJUSTMENT RANGES:
THICK PILE CARPET
11 TO 8
. . . . . . .
MEDIUM PILE CARPET
7 TO 4
. . . . .
LOW PILE CARPET
3 TO 1
. . . . . . . . .
MACHINE OPERATION
FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
1.
Turn on vacuum switch, located on control
console. Make sure air flow control knob is pushed
in all the way to direct air flow to brush area
(Figure 4).
FOR SAFETY: When using machine, do not pull
cord around sharp edges or corners. Do not
stretch cord. Do not close doors on cord. Do not
unplug by pulling on cord. Keep cord away from
heated surfaces.
WARNING: Do Not Pick Up Flammable Or
Toxic Materials, Burning Or Smoking Debris.
WARNING: Do Not Use Flammable Liquids Or
Operate Machine In Or Near Flammable Liquids,
Vapors Or Combustible Dusts.
FIG.
4
