20
d.Check the electrical fuses
Remove the main cover. The fuse is located in the position
shown in Fig. 17. Check Table 5 for the specifications.
e.Remove and reassemble the protective mesh
Do not use this truck if the protective mesh is damaged or not assembled correctly!
If you want to remove the protective mesh, remove the fixed screws and carefully remove the
protective mesh. The screws are still on the truck. When you reassemble the protective mesh, place
the mesh and fix each screw correctly. If you need to replace spare parts, please contact after-sales
service.
9
. TROUBLE SHOOTING
IF THE TRUCK HAS MALFUNCTIONS FOLLOW THE INSTRUCTIONS THAT MENTIONED IN
CHAPTER 6.
TROUBLE
CAUSE
REPAIR
Loads cannot be lifted
Load weight is too high
Load the truck within rated capacity.
Battery discharged
Charge the battery.
Lifting fuse faulty
Check and replace the lifting fuse.
Hydraulic oil level too low
Check and refill hydraulic oil.
Oil leakage
Check
and
repair
the
seal
performance of the oil hoses and/or
cylinder.
Oil suction failure
Excessive quantity of oil.
Reduce oil quantity.
Loads cannot be
lowered
Dirty oil blocks the control valve.
Check the hydraulic oil and clean
the control valve. Replace hydraulic
oil if necessary.
The lowering electromagnetic valve is
not activated or it is damaged.
Check or replace the lowering
electromagnetic valve .
Stacker cannot be
operated
Battery is charging
Charge the battery completely and
then remove the main power plug
form the electrical socket.
Battery not connected
Connect the battery correctly.
Fig. 17: Location of fuses
Table 6: Trouble shooting
Table 5: Specifications of the fuses
Specification
FU1
10A
FU2
0.5A
FU 01
80A
FU 02
200A
