Nobeltec WAAS GPS-18W, Руководство пользователя

Страница: 8 / 16

Nobeltec WAAS GPS-18W
Wiring the WAAS GPS-18W to the DB-9 Connector
TIP: This step requires a soldering iron and solder.
1. Solder the Brown TX wire directly to Pin 2.
2. Solder the Green RX wire to Pin 3.
3. Splice the Black wire. Solder ½ of the spliced Black wire to Pin 5 and ½ of the
spliced Black wire to a common ground on your electronics panel.
5. Connect the Red wire directly to your 12V electronics panel with a 1A fuse, either
in line or on the panel.
6. Check your solder connections carefully to verify that all wires are connected to
the proper pin numbers and that no solder is touching any other pin.
REMEMBER: The remaining wires (shown in Figure 5 with an * next to them) DO NOT get
connected to the DB-9 connector.
4
Chapter 2 Hardware Installation
Fig. 4 - Installing GPS Antenna - Side View
Fig. 5 - Diagram for GPS-18W with DB-9 Connector