5
NUTV5 QUAD
-( Four N5 tower speakers)
Rear
and
Front’s
crossover are set on
FULL
(full range) for tower speakers
If you have any doubts or questions, please contact us at
Installation Applications:
The NUTV5 series was designed to operate on 12 volts, negative-ground electrical systems. Using this
product with positive ground and/or voltages other than 12V systems may damage the product and will
void the warranty.
Safety Considerations:
•
Though this is a Marine IPX6 rated amplifier, mount the amplifier where it will be protected from
water/mud at
all times.
Water damages are not covered by the 1-year warranty.
•
Install the amplifier in a dry and well-ventilated location.
•
Do not touch the amplifier's surface
while you are riding or immediately after riding. having an
amplifier sealed to the elements at IPX6 level means that heat generated from the amp has
nowhere to escape. Playing hard with your HS4 might get it hot.
That’s fine and normal
. But,
avoid touching the amplifier’s surface
during or right after use.
•
Do not mount the amplifier in the engine
compartment or in any areas of extreme heat.
•
Securely mount the amplifier
so that it does not come loose in the event of a collision/sudden jolt
or as a result of repeated vibrations during normal operation.
•
Check before drilling
to make sure that you will not be drilling into an exterior panel/hull, fuel
tank, gas/brake line, wiring harness, or other vital system.
•
Do not run system wiring outside or underneath the vehicle
/vessel. This is an extremely
dangerous practice, which can result in severe damage/injury.
•
Protect all system wires from sharp edges
(metal, fiberglass, etc.) by carefully routing them, tying
them down and using grommets and loom where appropriate.