1. Install deck canopy Section and lower canopy Section.
2. Place upper canopy Section on a non-scratch surface, top side down.
NOTE:
Roof pins are shipped installed.
3. Install (6) 59-inch posts onto the roof pins. Install, but do not tighten, 3/8 x
0.75 capscrews and washers.
All capscrews should face the same
direction.
NOTE:
Two posts have an extra hole 11 inches from the bottom. These belong
on the front pins. See Figure 5 to locate front end of canopy Section.
4. Raise stairs to maximum height.
5. Stand upper canopy Section on its posts. With one person on each post
(6 people needed), lift the Section and carry it over the lower Section and
up the stair.
6. Place posts onto the straight pins. Secure posts to straight pins using 3/8
x 0.75 capscrews and washers. At each joint,
all four capscrews should
face the same direction.
7. Attach rear deck Section posts to front post brackets. Use a deck post
strap and three 3/8 x 2.75 capscrews, nuts, and washers on each post.
Locate strap and nuts on outside of tubes.
Truck Mounted Passenger Stair TMPS-200
Manual No. 307559
SEPTEMBER 30, 2008
CHAPTER 2 MAINTENANCE
PAGE 14
3 REMOVAL AND INSTALLATION
