NKT Photonics Koheras BOOSTIK LC, Руководство по эксплуатации продукта

Страница: 16 / 68

Front and rear panels
16
Variants
Three different BOOSTIK LC variants are available and mainly characterized by their
output power and center wavelength. Their specific characteristics can be seen in
Table 1 below.
Table 1 BOOSTIK LC variants and their characteristics
Front and rear panels
Front panel
The front panel shown in Figure 2 includes optical output and input fiber connectors
and status LEDs. The output fiber and connector (see table TBD) is fitted at the
factory.
See Table 1 on page 16 for more information on the optical outputs and connector
configuration.
The status LEDs on the front panel indicate the following states:
•
Power – the supply voltage status
•
Interlock – interlock circuit open/closed (not OK/OK)
•
Emission – the laser emission status (enabled or disabled)
•
Status – the module stability status
For more information see “Status LEDs” on page 20 .
Variant: 2 W@ 1550 nm 200 mW @ 1550 nm 200 mW @ 1064 nm
Compatible Koheras seed laser(s) E15, X15,C5 E15, X15,C5 Y10
Operation mode CW i
i. Continuous Wave - inherently single frequency
CW i CW i
Operating wavelength [nm] 1545 to 1565 1545 to 1565 1060 to 1075
Input power [mW] 1 to 50 10 to 50 10 to 50
Output power [mW] 2000 200 200
Output power tunability [%] 10 to 100 10 to 100 10 to 100
Polarization PM ii or SM iii
ii. Polarization Maintaining
iii. Singe Mode
PM ii PM ii
Input and output optical
termination
FC/APC
iv
iv. E2000 optional
FC/APC
iv
FC/APC
iv
Output fiber type PM1550 or SMF28 PM1150 PM980
2