NKT Photonics Koheras ACOUSTIK, Руководство по эксплуатации продукта

Страница: 71 / 96

71
CONTROL settings
Host IP address
To help prevent unauthorized access, the Koheras ACOUSTIK can be configured
to only accept packets from a single IP address assigned to the management PC.
Configure the Host IP address to the IP address of your management PC. When
set, the ACOUSTIK only accepts packets with a source address that matches the
Host IP address set and ignores all others. When set to 000.000.000.000
(default setting), the ACOUSTIK accepts packets with any source IP address.
Host port
The Host port sets the port address the ACOUSTIK uses for transmission of TCP
or UDP packets. The Host Port address set in the network connection of
CONTROL must match this address – default: 0.
Note: If the Host port is set to 0, the ACOUSTIK will use the same port address
for transmission as for reception i.e. the System port setting. The ports addresses
set in ACOUSTIK and CONTROL must match.
MAC Address
A unique MAC address of the ACOUSTIK is displayed only and cannot be set.
Watchdog
The Koheras ACOUSTIK features a watchdog for monitoring of USB or Ethernet
communication. If CONTROL is disconnected from the system, the watchdog
disables emission on each module after a set timeout expires.
Enable Watchdog
To turn the watchdog on, select ON from the drop-down menu next to Enable
watchdog. To turn the watchdog off, select OFF.
Watchdog timeout
When CONTROL communications is disconnected, the Watchdog timer starts.
When it reaches the Watchdog timeout setting, the emission from each
ACOUSTIK module is disabled. The Watchdog feature must be set to ON, then
set the timeout value from 1 to 255 seconds using the text input box.
Figure 35 Watchdog setting
Clock
Within the Clock setting menu the system date and time can be read or set
automatically by updating the settings from a connected PC.
When ON, laser emission
is disabled after timeout expiry