NKT Photonics A301-100-000, Руководство по эксплуатации продукта

Страница: 24 / 47

Optical Connections
24
Optical Connections
Following the steps in
Procedure 1
, to insert the output collimator of the SuperK
laser into the Optical Input receptacle of the SuperK VARIA.
Inserting the
collimator
Procedure 1 Inserting a SuperK output collimator
1. Disconnect power from the laser.
2. If not already installed, position the SuperK VARIA at its final operating
location and securing it to a suitable mounting surface.
3. Partially insert the laser’s output collimator barrel into the Optical Input
receptacle as shown in
Figure 9
.
Figure 9 Partially inserting the collimator
4. Holding the collar, rotate the collimator until the alignment key of the
collimator aligns with the slot at the optical port of the chassis (
Figure 10
).
Figure 10 Collimator alignment key and slot
Note: When the key is aligned with the slot, the axial orientation of the collimator
is correctly aligned.