13
Fig. 4.2.1.
If you use the machine for processing large pieces, you must place it on the work piece, on
which it will move itself. When approaching the material and leaving the work piece at the
end, it is advisable to suspend the machine on the belt, as illustrated in Fig. 4.1.1.
During electrical installation, proceed as follows:
- Check the frequency and voltage values on the motor identification label;
- Fit the end of the cable to the power supply with the plug according to your local power
supply network.
4.3
Checking before use
Important:
Never start the UZ 18 Hardworker without carrying out the checks described in this
section.
Before starting the machine, check whether it is in working order by means of the following
checks and inspections in order to ensure the highest possible efficiency and to meet safety
regulations:
- Check whether there are no loose screws or other parts.
- Make sure that all electrical connections are correct and the electrical cable is fixed in place
with a cable gland.
- To start the machine, proceed as follows:
Green button
(position B, Fig. 2.4.1).
Press the button to turn on the engine. BE CAREFUL
of the direction of rotation of the tool. Working direction is only clockwise.
To shut down the machine, proceed as follows:
Red button
(position B, Fig. 2.4.1). Press this button to disconnect the power supply. When
you press this button, the machine immediately stops prior to other commands.