19
ITS1A CLOCK
If segments stay on when they should go off, you can increase the
Reset Pulse Length
in the
Extra
config
screen. Generally you will want this value to be as low as possible as that will reduce flicker, but you also
want segments to go out!
Initial Configuration
All configuration of the clock is done via a web interface. The clock will publish a WiFi access point
whose name ends in
ITS1AClock
. Connect to it
–
the password is
secretsauce
. When you connect to it,
you should then be taken to a captive portal that will display this page:
•
You can set the time on the clock right from this page. Hit the
Set Clock Time
button. It will set
the time to whatever the time is on your phone/PC. The clock should stop counting and display
the time. The display might go blank
–
this is because it is pre-configured to only be on between
6am and 10pm. You can change this in the main config screen:
•
You can also configure the clock right from the captive portal. Hit the
Configure Clock
button!
•
Configure WiFi
and
Configure WiFi (no Scan)
, allow you to connect the clock to a router. If you
do this the clock will synchronize time with a time server on the internet and you can configure
the clock by pointing a browser at
. This page also allows you to rename
the clock, which will also rename the access point.
Содержание ITS1A
