Nivus NFP, Инструкция по эксплуатации

Страница: 41 / 87

Parameter Setting
NFP - rev. 04 / 23.05.2018 page 41
fied under >cycle< (see Fig. 27-2).
>Erase counter<
All day counters can be erased under >erase
counter<. Due to safety reasons it is required
to enter the PIN >2718< and confirmation
with >ENTER< after erasing.
1
Time of day totalising
2
Day values (and unit)
3
Current day with cumulated total
4
24 h-day totals
5
Date
Fig. 27-1 Display day values / info
1
Current time of day totalising
2
Programmable time of future totalising in „hours:minutes:seconds” format
Fig. 27-2 Time of day totalising (cycle)
Information concerning the totalising
If the transmitter is disconnected from mains at the time of totalising set, it is not possible to
create or to save a total for the respective day.
If the unit has been shut down temporarily between two totalising points, the flow rate
missed during the inoperative period is not going to be considered for totalising. There will
be no averaging interpolated replacing the lost flow rate.
>Error messages< >Error<
-
This menu is to monitor any interruptions in
the unit function. Errors are going to be
saved and ordered by type of error, date and
time.
-
Selecting the menu will always indicate the
latest error message. Browse through error