Fine/Coarse detection
– Change with ON/OFF key FINE = the 2 inner LED lights
”A” are flashing 3 times. COARSE = the 2 outer LED lights ”B” are flashing 3 times
Switch off
– Long press ON/OFF key to turn off the power.
Main receiver will be turned off automatically 15 minutes later without receip of
laser beam.
When the working voltage of battery pack drops to 6.4V, all LED light will be
flashing, and then Power will be switched off automatically, under this
situation, main receiver must be charged.
LED-Display:
2 upper red LED lights flashing=move main receiver upwards
Middle green LED lights flashing=main receiver on level
2 lower red LED lights flashing=move main receiver downwards
Cabin Receiver
Connect Cabin Receiver and Main Receiver by use of the connecting cable 14 to
socket 8 & 9, Fix cabin receiver in the cabin of the machine. Now the receiver can be
observed conveniently by the display, even if the position of the receiver is above the
cabin. Cabin Receiver has no own power supply, it is powered by main receiver.
Rechargeable battery and C/-
Machine control receiver has built-in 7.2V NiMh rechargeable battery pack. Remove
cover 7, and then connect charger with socket 2 and power supply, Recommended
charging time: 15hrs.
12V/24V Batter Cable:
Connect cabin receiver and Main Receiver with connection cable and then connect
12V/24V battery cable with socket, fix clamps on the car battery:
RED to positive pole (+) at battery.
BLACK to negative pole (-) at battery.
Supplied with:
Machine control receiver MC-1D main receiver with built-in rechargeable
battery pack
Cabin receiver MC-RC1 with connection cable
Charger
12/24V battery cable
Plastic carrying case
Technical Data:
Accuracy fine
+/-10mm
Accuracy coarse
+/-20mm
Rechargeable batteries/charger
7.2V NiMh/2500mAH
Operation time
40h
Charging time
15h
Operating temperature
-20C - +50C
Recommended storage temperature
-20C - +60C
Size
380x280x130mm
Weight
5.5kgs
