5
MAGW-40
Package Contents
Qty
Check
MYTON MAGW-40
1
Hex. Socket Screw Key 6
1
Single Ended Spanner 17
1
Bushing R3/8×NPT3/8
1
Instruction Manual
1
Declaration of Conformity
1
Caution for Use
1
MAG-50
Package Contents
Qty
Check
MYTON MAG-50
1
Air Hose Sub Assʼy
1
Exhaust Hose Assʼy
1
Side Handle Assʼy
1
Hex. Socket Screw Key 4
1
Pin Face Wrench
1
Bushing R3/8×NPT3/8
1
Instruction Manual
1
Declaration of Conformity
1
Caution for Use
1
MAG-70
Package Contents
Qty
Check
MYTON MAG-70
1
Side Handle B
1
Grip Guard B
1
Hex. Socket Screw Key 6
1
Hex. Socket Screw Key 10
1
Single Ended Spanner 41
1
Bushing R1/2×NPT1/2
1
Instruction Manual
1
Declaration of Conformity
1
Caution for Use
1
3. AIR SUPPLY
3-1. Air Pressure
Adjust air pressure with the air regulator to the
appropriate level for the pneumatic tool used.
Air pressure that is too low will stop the tool from
operating at full capacity.
Air pressure that is too high may cause damage to
the tool.
3-2. Air Line
(Fig.2)
Use a 9.5 mm (3/8”) I.D. connecting hose between
the compressor and the tool.
Drained water, etc., if flown into the tool, could
cause tool failure. Install an air filter between the
compressor and the tool.
Fig.2
3-3. Lubrication
Install an oiler between the compressor and the tool.
Use the machine oil ISO VG-10. Failure to lubricate
as required may result in damage to the tool. Use of
oil that is too thick will reduce the performance of the
tool.
4. PREPARATION (MAG-50)
4-1. How to attach Inlet Hose and Exhaust Hose.
●
Insert the Inlet Hose of the male thread into the
Exhaust Hose from the tail.
●
Screw the male thread of the Inlet Hose on the
thread of the body. Then tighten enough with the
tightening torque of 30N
·
m.
●
Screw the Exhaust Hose on the body.
Fig.3
4-2. Thread Size of Hose Fitting
The product comes with a metal fitting with R(metric)
thread. Connect the Bushing R thread×NPT thread
in the vinyl bag containing standard accessories,
if you would like to have American NPT thread
instead.
4-3. Construction of Side Handle (MAG-50,MAG-70)
Before using MAG-50, MAG-70, you must set up
Side Handle and Grip Guard indicated as follows.
Fig.4
Air Regulator
Oiler
Air Filter
Compressor
Lubrication
Tool
9.5mm (3/8”) I.D.
Hose
Cupla
