7
4.HOW
TO
OPERATE
1. Attaching and detaching a bit
Move the holder clamp as shown in the diagram below, and insert the bit.
2. Torque Adjustment
To adjust the bit torque, detach torque adjustment ring cover and vary the amount of screwing-in of
the torque adjustment ring.
3. Screwing
1)
After connecting the screwdriver to the controller, plug into the power source.
2)
Set the changeover switch at
(forward), and trigger the switch. The bit starts running.
3)
When the set torque has been reached, the clutch shuts off immediately and the motor stops
at the same time. Return the trigger to the original position.
4)
Unscrewing
Turn the changeover switch to (reverse) and trigger the switch.
4. Use the screwdrivers in combination with the following special controllers
・
DLC16S : This controller features the speed control.
・
Speed control: Set low speed for small size screw and high speed for larger screws.
Torque adjustment ring
Torque adjustment ring cover
Holder clamp
CAUTION
Implement the operation properly. Insufficiently pressed blade or inadequately pulled lever may
result in a malfunctioned and defective driver, or related work damage.
Guide for 5P plug-in
5P plug
