4
INSTRUCTIONS
FOR
THIS TOOL
About Your Tool
WARNING
●
Wear protective glasses and a dustproof mask.
Operation generates chips and dust particles, etc.
which may cause eye and/or respiratory injury:
Always use PPE (Personal Protective Equipment)
for eye and respiratory protection.
●
Always wear suitable hearing protection.
The tool generates loud noise. Always use ear plugs
for hearing protection. Take necessary measures to
comply with the local regulatory requirements and
laws with regard to noise level, or do better.
●
When the drill passes through or locked during
drilling or tapping, the main body may be Swung
around. If it occurs, release the Trigger quickly
to avoid injury.
●
Do not tap a blind hole using this air drill.
●
Never touch moving parts.
CAUTION
●
For tapping, always use tapping paste.
●
Use sharp taps.
●
Use a taper tap (No.1) and a plug tap (No.2) for
tapping.
1. USAGE
This tool is for drilling work with a drill bit. Tapping
(right-hand screw) is also possible by using the
reversible function.
2. CHECK THE CONTENTS OF THE PACKAGE
Check the contents and make sure that the tool
does not have any damage which may have
occurred during transportation. The contents should
correspond to the list as follows. In case of damage/
missing parts, please contact the sales agent from
whom you purchased the tool.
ADR-65
Package Contents
Qty
Check
ADR-65
1
30SH
1
Chuck Handle
1
Bushing R1/4×NPT1/4
1
Instruction Manual
1
Declaration of Conformity
1
Caution for Use
1
ADR-100
Package Contents
Qty
Check
ADR-100
1
30SH
1
Chuck Handle
1
Bushing R1/4×NPT1/4
1
Instruction Manual
1
Declaration of Conformity
1
Caution for Use
1
3. AIR SUPPLY
3-1. Air Pressure
Adjust air pressure with the air regulator to the level
appropriate for the pneumatic tool used.
Air pressure that is too low will fails the tool to
operate at full capacity
Air pressure that is too high may cause damage to
the tool.
3-2. Air Line
(Fig.1)
Use a 9.5mm (3/8”) I.D. connecting hose between
the compressor and the tool.
Drained water, etc., if flown into the tool, could
cause tool failure. Install an air filter, bsetween the
compressor and the tool.
Air Regulator
Oiler
Air Filter
Compressor
Lubrication
Tool
9.5mm (3/8”) I.D.
Hose
Cupla
Fig. 1
3-3. Lubrication
Install an oiler between the compressor and the tool.
Use the machine oil ISO VG-10. Failure to lubricate
as required may result in damage to the tool. Use of
oil that is too thick will reduce the performance of the
tool.