Nitta PolySprint FP30-10-100, Руководство по эксплуатации

Страница: 10 / 14

- 9 -
8. Troubleshooting
If there are any finger joints which are not cut out properly when a belt is punched,
follow the directions described in the “Maintenance” section on pages 9-11.
If the problem is not solved after following these directions, please contact Nitta,
your local distributor or agent in your area for advice.
9. Maintenance
9-1) How to Perform Maintenance
You can change the position of the cutting sheet and both sides of the cutting
sheet can be used. Adjusting the position may solve any problems where a
portion of the finger joint is not cut out.
The cutting sheet is consumable. Specify the cutting sheet for FP30-10-100 Finger
Puncher when you order a new one.
9-2) Required Tool
Hexagon wrench (3 mm)
9-3-1) How to change the position of the cutting sheet
①
Loosen the four hexagon socket head cap
screws for the cutting sheet by using a hexagon
wrench.
※
Do not pull out hexagon socket head cap
screws. Just loosening hexagon socket
head cap screws is enough.
※
Do not loosen hexagon socket head cap
screws fixing the clear sheet.
Hexagon socket head
cap screws
Hexagon
socket head
cap screws
for fixing the
clear sheet