Ad
vantage”
–
Superior Product
Superior Quality
Superior Service
Toll-free: 1-800-221-3689
Fax: 770-623-1398
“The
7605 Nitta Drive
Suwanee, GA
30024
Page 2 of 4
For all your belting needs.
Instructions for:
Finger-Splicing
Carryflex
TM
CFTG-60SG-30
Placing Belt in Puncher
1)
Loosen bolt on clamping bar and insert belt end in one side of
finger puncher.
2)
Place belt to align marks on belt with inside or outside edge of
clamps. Be sure to use this same set position for all punches.
3)
Fasten the bolts on both clamps with a wrench to hold the belt in
place. The belt will stay fixed with minimal pressure, so be sure
not to over-tighten the clamps while at the same time making
certain the belt does not move when pulled.
4)
Belt insertion direction:
a)
Continuous punching: After punching one end of belt, pull
belt through clamping bar until reaching next punching
position.
b)
Cutting both ends of belt: When punching, feed one end of
belt into cutter,
moving the
belt’s
v-guide all the way to
one edge of the
cutter’s
v-guide groove
. After punching,
feed other end of belt into cutter from opposite direction, but
be sure to
align edge of v-guide with same edge of v-guide
groove
used for first punch
.
Cutting Fingers into Belt (10mm Pitch Indexing)
1)
Align the support table so that guide pins on the cutter line up with
a set of alignment holes on either end of the clamps.
2)
Push downward on the handle carefully to check the alignment of
the pins.
3)
Return the handle and move the support table over so the next set
will accept the guide pins.
4)
Repeat steps 3-2 and 3-3.
2
3
