Instructions for:
Finger-Splicing
Carryflex
TM
Ad
vantage”
–
Superior Product
Superior Quality
Superior Service
Toll-free: 1-800-221-3689
Fax: 770-623-1398
“The
7605 Nitta Drive
Suwanee, GA
30024
Page 1 of 4
For all your belting needs.
CFTG-60SG-30
•
Carryflex
TM
belt CFTG-60SG-30
•
Steel ruler and pen (for marking)
•
Finger Puncher FP-120G-60
•
Pre-setter PSCFTG18G30MM (pre-setter for CFTG-60SG-30 material includes top plate, lower mold
with groove for V-guide, and silicon sheet)
•
Heating/Cooling Press
NPS-2005
Belt Type
Finger
Shape
Setting
Heating
Temp.
Heating
Time
Cooling
Temp.
CFTG-60SG-30
10 x 120
Bottom Mold/Belt (guide face down)/Silicon
Sheet/Top Plate
170°C
450 sec.
50°C
Measuring Belt Length
1)
Make the first mark 160mm from the edge of the belt.
(See diagram to right.)
2)
Based on the first mark, make a second mark at the ending
point. (Put both marks on the front side, i.e. on the pulley
contact side.)
3)
When consecutively making endless belts, obtain required
belt length and, from the second mark made at the
preceding finger joint, measure out the required belt length
and make another mark. Repeat the above process. By
doing this, punching can always be done at the right position
and there will be no wasted belt.
1
