Sdasdasdsdfdsdcdscsdcdcd
cdcsc
9
Das Bild kann zurzeit nicht angezeigt werden.
Nitronic AG
Mattenstrasse 11
CH – 2555 Brügg
Tel. +41 32 373 70 70
Switzerland
Set the diameter setting
(4)
to a diameter of
0 mm
.
Slowly push the stripping head
(5)
back and forth.
(Fig. 15)
This will cause the four stripping blades to automatically
settle into the tracks on the guide plate.
Pull the stripping head
(5)
backwards as far as it will go and,
holding this position, tighten the end cap
(6)
.
(Fig. 15)
The
Nitronic MiniStrip
is now ready for use.
Changing the stripping blades (with centering unit)
The stripping blades must only be inspected and replaced by a suitably trained person.
Set the diameter setting
(4)
to
1.5 mm
. (
Fig. 10
)
In order to avoid losing the very small stripping blades, we
recommend that you put down a dark-colored smooth mat
and use a pair of tweezers. All four stripping blades must
be changed at the same time in order to maintain a
consistent stripping quality
Fig. 15 Settle blades
Fig. 16. Diameter Setting
5
6
4
