Sdasdasdsdfdsdcdscsdcdcd
cdcsc
8
Das Bild kann zurzeit nicht angezeigt werden.
Nitronic AG
Mattenstrasse 11
CH – 2555 Brügg
Tel. +41 32 373 70 70
Switzerland
10
Unscrew the end cap
(6)
and carefully pull out the cover
plate
(7)
. The four stripping blades
(8)
will now be visible.
(Fig. 11)
In order to avoid losing the very small stripping blades,
we recommend that you put down a dark-colored smooth
mat and use a pair of tweezers. All four stripping blades
must be changed at the same time in order to maintain a
consistent stripping quality
Remove each stripping blade
(8)
individually from the guide
plate
(9)
.
If necessary, carefully clean the guide plate
(9)
with a dry
brush
Insert new stripping blades
(8)
individually. As far as
possible, align the stripping blades with the track so that
the blades do not subsequently jam.
(Fig. 13)
Carefully replace the cover plate
(7)
. The chamfer
(10)
must point towards the outside.
(Fig. 14)
Screw the end cap
(6)
back on again, but
do not tighten
.
(Fig. 14)
Fig. 11 Removing cap and cover
Fig 13.Insert blades
Fig. 14 Assemble plate and cover
9
8
7
6
7
6
8
10
