niteo POJM220033, Инструкция по эксплуатации

Страница: 31 / 36

31
Vertical position
7.2 Assembly/disassembly of the sanding table
Installing the sanding table:
1 . To mount the sanding table (9), slide the sanding table holder (8) onto the device .
2 . Insert the rod with the knurled nut attached (18) and screw the screw (7) tightly.
Disassembling the sanding table:
1 . To disassemble the sanding table, undo the screw (7) completely .
2 . Pull out the rod connecting the screw (7) to the knurled nut (18) and remove the sanding
table holder (8) from the machine .
7.3 Installing the sandpaper
NOTE: Placing the sandpaper on the sanding disc will be easier if you disassemble the sanding
table (9) and the table holder (9) beforehand .
When applying the sandpaper (17), press it evenly to the sanding disc (2) .
Only Velcro-backed sandpaper may be used with this power tool.
7.4 Setting the angle of the sanding table
The angle of the sanding table (9) can be adjusted continuously between -10° and +50° .
1 .
To set the angle of the sanding table, loosen the screw (7) .
2 . Set the desired angle with the knurled nut (18) and the angle scale (6).
3 . Tighten the screws tightly again (7) .
7.5 Using the angle guide
1 . Loosen the screw of the angle guide(13) .
2 . Slide the angle guide rail (12) to the desired position in the slot (10) on the sanding table (9) .
3 . Using the scale, set the desired angle on the marking located on the rail (12).
4 . Fix the angle guide (11) by turning the screw (13) firmly.