INSTALLATION
A.
Remove top cap of pool vertical post nearest your installation.
B.
Lift one end of your pool’s top ledge. The top ledge is comprised of flat sections that extend
around the top of the pool wall.
C.
Slide the pool light onto the pool wall submerging the light in the water. Locate the light in the
middle of the top rail to allow for easier installation.
D.
Hold the light down so that the top of the mounting bracket is flush with the top of pool wall. Turn
thumbwheel in a clockwise direction to tighten securely to the wall.
E.
Be sure that wire runs completely through the channel of the mounting bracket.
F.
Replace top rail and cap.
G.
Make sure that water level is above the minimum water line on the light. If not add water to pool.
H.
The transformer should be mounted on a nearby vertical surface using the screws provided.
Mount the transformer a minimum of 18 inches from the ground.
I.
Plug unit only into a GFCI 110V socket. DO NOT USE EXTENSION CORDS.
OPERATION
Plug light into GFI protected socket when light is needed in pool. Push switch on power supply to turn
on. Push power switch again to turn off.
