B.
Remove the bulb from its box being careful not to touch the lens of the bulb. Install
the bulb by pressing the two bronze legs of the bulb into the ceramic socket in the
light housing as shown in FIG 3.
C.
Be sure that the bulb is firmly pressed into the socket.
D.
BE CAREFUL NOT TO BURN YOURSELF AS THE BULB GETS HOT QUICKLY AND
SHOULD BE TURNED OFF IMMEDIATELY UPON SUCCESSFUL TESTING. OPER-
ATION OF THIS FIXTURE OUT OF WATER FOR ANY PROLONGED TIME WILL
DAMAGE THE UNIT AND VOID THE WARRANTY. Plug the light into a wall outlet.
Turn switch on. If light turns on, the test was successful. Unplug the unit. Move to
step E. If light does not turn on, unplug unit from wall and reinstall light bulb. Repeat
test again. If it is still not working, contact SPQ Brands customer service at (609) 212-
0221.
E.
Carefully replace the lens making sure that there is an even flat fit in the light body.
F.
Place the seal ring carefully over the lens making sure it is on straight. Now turn in a
clockwise direction until the ring begins to tighten up. You may hear a clicking sound
which is normal. This is a safety feature designed
to not allow the light seal to loosen or be removed
without the key.
G.
Continue to turn clockwise until the index mark on
the seal ring is even with the light body as shown in
Figure 4. NOTE DO NOT OVER TIGHTEN OR
TURN BACK SEAL RING IN A COUNTER CLOCK-
WISE FASHION AS THIS WILL CAUSE LEAKAGE!
H.
Light is ready to install.
