Doc XCAM190
NiteDevil Traditional Wide Dynamic
Email:
Last Revised: 03/011/2010
CAM190 12v DC only
CAM192 Dual voltage 12vDC/24vAC
CAM194 240v AC
All 3 cameras provide a resolution of
600TVL
in colour and
700TVL
in b/w. These cameras come
with many of the NiteDevil features including an OSD menu, the SENS-UP feature allowing minimum
illumination down to an incredible
0.00019 Lux
and a
WDR
option.
Powering the Camera
CAM190
The CAM190 requires a 12v DC regulated power supply providing a minimum of
140mA. When connecting to any 12v DC power supply, always use a regulated
supply. The camera has a terminal connection. This camera is polarity sensitive so
ensure that the positive and negative connections are correct. If incorrectly
connected damage to the camera may result. The 12V DC cameras require a power
supply that has a continuous rating of 140mA or higher per camera. It is
recommended that you allow headroom per camera to be on the safe side especially
taking into account any extra load created by adding an auto-iris lens (typically
10mA). The power supply you choose must be a well regulated one giving a smooth
regulated 12V DC output and it is recommended that it should be rated at no less
than 200mA.
WARNING
- This power supply
must not
be a security type used in intruder alarms as the over voltage may damage the
camera and void the warranty. The earthing arrangement of an intruder type alarm PSU may give rise to problematic
“earth-loops” and poor voltage regulation can give poor/noisy image quality. We offer no technical support or warranty
with the camera if you use a 13.8V intruder alarm PSU as it is contrary to the installation & usage instructions of the
camera. The terminal strip will facilitate easier and faster power connection without the hassle of soldering. The terminal
connection can be seen in the picture above. The 12V+ and -0v connections from the power supply must be connected
correctly. If you have a 2.1mm jack plug connected to your power supply you will need to cut this off and use the bare
wires to connect to the terminal strip. Note that the 12V positive is the wire that was connected to the centre pin of the
jack plug and the 0V wire was connected to the outer case.
Features
1/3” Sony Super HAD CCD 600/700 TVL
Low Light 0.00019Lux
Wide Dynamic Range setting
Maximum 2watts power consumption
3 Lens Options
SENS-UP auto function 2x – 256x
Built-in OSD menu
Built-in 3DNR function
Privacy Masking
RS485 menu control
Electronic Shutter
Motion Detection Alarm Function
Digital Zoom up to 32x
Contrast & Sharpness adjustments
NiteDevil CAM190/192/194
These
NiteDevil Cameras
have Digital WDR
functionality allowing improved picture
quality in mixed lighting conditions. They are
complimented with an OSD menu, allowing
access via camera or RS485, privacy masking,
digital zoom to 32x and adjustable NiteDevil
settings. The cameras are supplied in three
versions:
Lens supplied separately
3 fitted lens options
CAM190
