23
Setting and using wireless strobe
1. Put fully charged batteries into the commander and each NAS strobe.
2. For one NAS commander control
Check the channel settings and pairing of each strobe
Start pairing and wait for the pairing process between
both commander and strobes are completed
Press the pilot button on the Air 10s. You will see that the paired strobes
will fire a test flash.This will confirm that the pairing is completed.
For Multi NAS commanders control
Check the channel settings of each strobe and NAS commanders
Switch on the Open Mode of all strobes and NAS commanders
Press the pilot button on the Air 10s. You will see that each of the paired strobes
will fire a test flash. This will confirm that the pairing is complete
To start the set up process and use the wireless strobe:
3. Set each strobe to different groups for receiving different control from NAS commander
4. Place the strobe on the flash stand or any compatible lighting accessories
(e.g. flash stand, pan-tilt head …… etc.). Place it within the signal coverage area.
(Signal coverage distance of Air 10s is 100m, depending on the surrounding factors.)
5. Press the Pilot button on commander to test the signal transmission of the strobe.
Adjust all settings through the commander and start the shooting.
