Nisca PR5300, Руководство пользователя

Страница: 15 / 55

11
1. Make sure the computer and printer are turned off.
2. Each SCSI device to be connected in the SCSI chain must be identified with an
individual ID number. There are 7 potential SCSI ID numbers to specify and each SCSI
device must be assigned its own unique ID number. The default SCSI ID number for the
printer is 4.
3. You can set the ID number in the printer by accessing the User Mode Menu. Press and
hold the Menu button on the LCD until it displays “User Mode”.
4. Press the EXE button several times until the SCSI ID sub menu is displayed. Press the
Menu button to enter this menu and select the appropriate ID number using the EXE
button. The numbers can be between 0-7.
5. Select “Return to Normal Mode” with the MENU button and press the EXE button to
return to the “Ready to Print” display.
6. Depending on where your printer exists on the SCSI chain will determine the selection of
the termination switch. If the printer is in the middle of the chain, then the terminating
switch should be in the “OFF” position. If the printer is at the end of the chain, then the
terminating switch should be set to “ON”.
7. Insert the power cord into the power receptacle on the rear of the printer. Plug the other
end into an available wall outlet.
Note The SCSI ID cannot be the same for any other device in your system. SCSI ID 0
is reserved for boot devices and is therefore not recommended to use. The SCSI
interface allows for very high-speed data transmissions. To ensure error free data
transmissions, use the shortest cable possible.
Parallel Connection
To connect the printer to your computer, obtain the appropriate interface cable. A printer to PC
interface cable is a non standard accessory.