NIPPY NP-S7B Ski-mini, Инструкция по эксплуатации

Страница: 13 / 16

11
Abnormality Cause Adjusting method
Work piece goes under the
blade
The space between presser foot and the
blade is narrow
Thick the skiving thickness, because it is too thin
The presser foot is below the blade edge Raise the presser foot
The space between the feed roll and the
blade is too wide
Bring the feed roll closer to the blade
The sharpness of the blade is bad Replace with a new one
The spring tension adjuster is too device is
too weak
Strong the spring tension adjuster
The skived scrap is rolled
upward
The dust is full of dust box Throw away the dust
There are irregularities on the surface of
the feed roll
Replace with a new one
The sharpness of the blade
gets worse soon
stopping and running the processed
skiving piece in the middle of work
Finish the processed product to the end
Skiving for something thick, hard or hard to
cut
When skiving something that is likely to damage the
blade, replace with a new one frequently
Blade
doesn’t move
Foreign matter is caught at both ends of
the blade
Because the safety device is working, Eliminate the
cause of overload (such as the dust)
Main power or power switch is off Turn on main power or power switch
Spindle motor failure Replace with a new one
Power supply circuit failure Request repair from our company
The feed roll doesn’t move
Foreign matter such as shavings is caught
Because the safety device is working, Eliminate the
cause of overload (such as the dust)
Feed motor failure Replace with a new one
Power supply circuit failure Request repair from our company
Cannot turn on
Power cord is not stuck Plug in the power code
The fuse is blown Replace fuse with a new one
Power supply circuit failure Request repair from our company