D-F10072 NP-K3053/K2053 Product Specifications Rev.1.00
24
4.2 Error Handling
1) Details of Error Detections
Item Status
Status
Information
ALARM
Status
Release method
Communication
232C communication error
– –
Rectify Communication
Error Parity
Conditions
Overrun
Framing
Normal Normal
status
–
OFF
Print Start Status Print start setting by
bit7 1
OFF
Print finish setting
command (not error)
by command
Presenter Clamp Presenter or bezel is
bit6 1
BLINK
Pull out the paper
clamping the paper.
Paper Detection Unable to detect paper
bit5 1
BLINK
Open the bezel unit
Error while
presenter
and close after
movement
removing error factor.
Auto Cutter Error Cutter PaperJam
bit4 1
BLINK
Refer to [4.8 How to
remove remaining paper
and jammed paper]
Head Temperature Head temperature at
bit3 1
BLINK
Auto recovery at
Abnormal
over approx. 70ºC~
approx. 65ºC of head
Temperature(*1)
Presenter Ejection Presenter unable to eject
Pull out the paper from
Error
the
presenter
Paper End
No paper
bit2 1
ON
Paper replenishment
Bezel Unit Open Beze Unit Open
bit1 1
ON
Close bezel unit
Paper Near End Detection of remaining paper
bit0 1
BLINK
Paper replenishment
Paper NE sensor detection
(MS2-4:
OFF)
Printer stops all operations and turns ON error bit of the status information when detecting
above errors except “Communication Error”, “Paper NE” and “Print start status”.
*1 When printing is restarted after auto-recovery of head temperature abnormal, it may
cause the print density unevenness.
2) Recovery and release from error status
Remove factor of error status occurring and will recover by restarting the power ON or
pressing the reset switch. If conducting recovery/release operation, it requires to set again
because the printer will be initialized.
Please beware when data remains in buffer because it will be deleted.
