6
USING THE CONTROL PANEL
PREPARING FOR USE
1
Delay Brew Button
2
Water Temperature Button
3
Keep Warm Indicator
4
Keep Warm Button (Orange)
5
Programmable Digital Clock and
Ounce Display
6
Power Button
7
Drip Stop Indicator
8
Smart Sensing Mode Indicators
9
Multi-Serve Dial and Start/Stop Button
10
Brew Style Button
11
Intelligent Clean Cycle Indicator
(Orange)
12
Intelligent Clean Cycle Button
13
Hour/Minute Button
5
7
ninjakitchen.com
1-877-646-5288
NOTE:
If you unplug the brewer or in the event of a power loss, you will need to reset
the clock the next time the brewer is plugged in.
NOTE:
This calibration is permanently saved and will not be lost if power is lost
or brewer is unplugged. Brewer can be recalibrated at any time if the altitude where it is
being used changes.
NOTE:
At any time, you can set the clock by turning on the brewer, pressing the
HR/MIN button, and following steps 3–4.
SETTING THE CLOCK
1
When the brewer is first plugged in, HR/MIN will illuminate to indicate that the time
has not been set.
2
Press the HR/MIN button to set the clock.
3
Use the Multi-Serve Dial to select the correct hour. Then, press the START BREW
button to toggle to minutes.
4
Use the dial again to select the correct minute, and press the START BREW button
to set the clock at the displayed time.
HIGH-ALTITUDE CALIBRATION BREW
Required for users in high-altitude areas. Not running the high-altitude calibration brew in
a high-altitude area will result in excessive steaming during brewing.
Because water boils at a lower temperature at higher altitudes, running a calibration
cycle before your first brew allows the brewer to detect the boiling point of water at
your location. Running a calibration cycle will help deliver a consistent brew each time.
1
Fill the water reservoir up to, but not exceeding, the Full line.
2
Insert the brew basket and slide the sliding lid closed, then place an empty carafe
on the base.
3
Press and hold both BREW STYLE and HR/MIN until you hear a confirmation sound.
4
A calibration cycle will begin, and the display will count down until the Altitude
calibration is complete. When complete, the brewer will beep and display “End”
on the dial. Discard the water in the carafe.
5
1
13
9
2
12
3
8
7
Not all functions are available on all models.
SMART SENSING MODE INDICATORS
11
4
10
MODE INDICATORS
STATE
Grounds:
The Sliding Lid is slid all the way forward over the brew basket
until it is completely closed and the brewer is ready to brew grounds.
Pods:
The Ninja® Pod Adapter is inserted, locked, and shut, and
the brewer is ready to brew pods.
Water:
The dial on the left side of the brewer is turned to the
water droplet icon, and the brewer is ready to dispense hot water
(not available on all models).
No State:
One of the above criteria has not been met.