13
14
1-877-646-5288
ninjakitchen .com
1
Place the unplugged motor
base on a clean, dry, and
level surface such as a
countertop or table. Press
downward on the motor
base to adhere the suction
cups to the work surface.
Plug the motor base into a
wall outlet.
2
Lower the Total Crushing
Pitcher onto the motor
base. The handle should
be aligned slightly to the
right and the pitcher should
be oriented so the LOCK
symbols are visible on the
motor base. Then rotate
the pitcher clockwise until it
clicks into place.
TIP:
If the Stacked Blade
Assembly is not fully
seated, you will not be
able to install and lock the
lid.
TIP:
To learn more about
the unit’s programs, refer
to page 10.
NOTE:
Pre-set programs
have pauses and changes in
speed throughout the cycle.
NOTE:
DO NOT
add
ingredients before completing
installation of the Stacked
Blade Assembly.
NOTE:
The pitcher can only
be installed in one orientation.
The handle must be
positioned on the front-right
corner of the motor base to
operate the appliance.
USING YOUR TOTAL CRUSHING®
PITCHER
IMPORTANT:
Review all
warnings on pages 3–6
before proceeding.
3
Exercising care, grasp the
Stacked Blade Assembly
by the top of the shaft and
place it onto the drive gear
inside the pitcher. Note
that the blade assembly
will fit loosely onto the
drive gear.
4
Add ingredients, making
sure to not exceed the
Max Fill line marked on the
side of the pitcher.
5
Place the lid on the pitcher,
aligning the triangle symbol
located on the lid with the
triangle symbol located on
the pitcher’s handle. Press
down on the handle until it
clicks into place. The triangle
symbols MUST be aligned
for the lid to lock onto place
and the unit to operate.
When the unit is connected
to power and the container
is correctly locked onto
the motor base, press the
Power symbol to turn unit
on. The available program
buttons will illuminate and
the unit will be ready for use.
