.25.
6. Operation
B)Select Power Curve:
Select Power Curve
Figure 6.18
Please follow below steps to select power curve:
Step1:
Set Grid OFF
before use this function (refer to 6.5.1).
Step2:
Select the Power Curve menu to display the following
(refer to figure 6.18 & 6.19)
:
YES=<ENT> NO=<ESC>
Curve No.: 01
Figure 6.19
NOTE:
The 01,02,03 power curve is the user edit ; the 04 power curve is the default
value and could not be changed.
Press the ENTER to save power curve. Pressing ESC key to cancel pervious setting
and back to pervious menu.
Step3: Set GRID ON
to start the inverter. (refer to 6.5.1)
.
NOTE:
After the set power curve, please select power curve to see if the selected
power curve No. is the right one!
Step6:
Set to GRID-ON
to start the inverter (refer to 6.5.1)
.
Step5: Select corresponding power curve.
Enter select power curve, select the power curve No. you want to execute.
6. Operation
.24.
Figure 6.16 example of set power curve
030V: 0100W
040V: 0200W
Pressing UP/DOWN keys to set power curve. Pressing ENTER key to move the
selected digit to the next (from left to right). Press the ESC key to save the power
curve point ( see Figure 6.16).
Set 030V: 0100W
040V: 0200W
Step4: Set power curve
NOTE1:
Please calculate the current of each point to the make sure it is not higher
than the Max. input current of the inverter.
Figure 6.17
Save & Send
Cancel & Exit
After finish all points of the power curve, press ESC to return to previous menu (see
fig. 6.20), then press ENTER to select <Save & Send>. Pressing ESC key to cancel
the setting and back to pervious menu
( see Figure 6.17).
NOTE2:
For 1-2kW models the value of power should be times of 10. For 2.5-5kW
models the value of power should be times of 30. Otherwise the inverter will
adjust the value to match this rule automatically.
NOTE:
After the set power curve, please select power curve to see if the selected
power curve No. is the right one!
Step6:
Set to GRID-ON
to start the inverter (refer to 6.5.1)
.
Step5: Select corresponding power curve.
Enter select power curve, select the power curve No. you want to execute.
